Alloys and offsets

Mitsubishi Outlander PHEV Forum

Help Support Mitsubishi Outlander PHEV Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Superflan

Active member
Joined
Jun 12, 2018
Messages
31
Hi,

Ive got a good deal on a set of 4 OZ Ultraleggera 7x16" ET45. However, Ive got 2 questions in mind:

Would they fit or are they too close to the inside compared to stock 6.5x16" ET38 ?

I read (in the OZ users manual) that those wheels are limited to a 560kg (iirc) load. Should I really avoid putting them on the 2 ton PHEV?
 
I would not use them on the PHEV. They probably will not break, but as the maximum loaded weight of the PHEV exceeds the wheel rating, you might get into trouble with the MOT/Law/insurance.
 
Should I stick to OEM 16" alloys? There’s some at 80 AUD each but I’ll have to find a transporter that can make them travel by sea, else it’s absurdly expensive
 
Back
Top