Mitsubishi Outlander PHEV Forum
http://www.myoutlanderphev.com/forum/

First Poll for MMC Japan
http://www.myoutlanderphev.com/forum/viewtopic.php?f=9&t=4204
Page 1 of 1

Author:  Phevy [ Thu Jan 31, 2019 6:26 pm ]
Post subject:  First Poll for MMC Japan

Here is the first poll for request to the Engineers in Japan.

Author:  ChrisMiller [ Fri Feb 01, 2019 2:20 am ]
Post subject:  Re: First Poll for MMC Japan

MPG above 99 is already displayed on post-facelift models. It's still limited to 999, though :).

Author:  richr [ Fri Feb 01, 2019 3:59 am ]
Post subject:  Re: First Poll for MMC Japan

ChrisMiller wrote:
MPG above 99 is already displayed on post-facelift models. It's still limited to 999, though :).


Hopefully that means there is a chance the code can be included on the pre-facelift firmware without too much work.

Author:  twosout [ Fri Feb 01, 2019 4:09 am ]
Post subject:  Re: First Poll for MMC Japan

What happened to 'Sticky Buttons'?
I'd like it to remember the Speed Limiter settings and 'B-level' after I've switched off.

EDIT:
OK, I've since seen that 'Sticky Buttons' are in a "Second Poll"

Author:  Phevy [ Sun Feb 10, 2019 7:15 pm ]
Post subject:  Re: First Poll for MMC Japan

Bump, since it's not a sticky (yet)

Author:  Mitch [ Sun Feb 10, 2019 11:44 pm ]
Post subject:  Re: First Poll for MMC Japan

Instead of "Allow to connect to selected WIFI" it would be much better to have a online version, so the car is available regardless from any wifi

Author:  AintBigAintClever [ Mon Feb 11, 2019 1:29 am ]
Post subject:  Re: First Poll for MMC Japan

Would "better control of electric heater" come under the "charging" category? I'd like to see the electric pre-heater work without being hindered by the charging timer.

Author:  elm70 [ Mon Feb 11, 2019 3:06 am ]
Post subject:  Re: First Poll for MMC Japan

AintBigAintClever wrote:
Would "better control of electric heater" come under the "charging" category? I'd like to see the electric pre-heater work without being hindered by the charging timer.


Would be nice to have this inside the Eco to EV re-purpose

In ECO mode, it should be always prevent to start ICE, both for cabin heating, and as well for a little extra push on the accelerator pedal (only a kick down should trigger a ICE start in ECO mode).

If they will provide this not only in the new PHEV (which somehow with the EV button are covering most of the original "problems"), but as well to the old PHEV by updating the ECO button function ... it would be a super customer care/focus from Mitsubishi

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/