Thanks for all of the advice everyone.
I have been working it again tonight, did about 100 movements of the lever from under the car using some mole grips and there is a significant improvement with the lever now only around 5mm from returning to the home position. I'll keep up with this each...
There's about 30mm movement before some resistance is felt and if immediately re applied it travels about half way before resistance.
I worked it for a while last night then pulled lever fully on and released and left hand brake off over night hoping that the spring tension would slowly help...
So I've had a go with the wd40 but couldn't get it to fully return without assistance and have also applied some copper grease. I think the problem is getting the lube to the moving part as there is a rubber boot between the arm and caliper that is covering this. I'll leave it a while with the...
Had a look under car today and handbrake arm on offside caliper is not releasing when handbrake is released although it is possible to move this with a little persuasion but it sticks once again when handbrake applied, maybe some lube can release this?
Whilst this is an issue the handbrake...
Hi, The parking brake on my PHEV no longer holds when on a hill and the lever is fully up. I've had a look and the pads still seem to have plenty of life left in them. Can anyone advise is there are any cable adjustment nuts at the lever and is there a relatively easy way to access them or...
I've tried holding info button until spanner flashes then pressing info+right arrow although it doesn't seem to do anything, the spanner continues to flash for a while and then stops, unless I'm doing it wrong. My understanding was with the ignition off press info until the spanner is shown and...
Hi, I've just had my car serviced today although they haven't reset the service indicator. I'm just wondering if this is something I can do at home rather than having to go back to the garage. I've seen a video on you tube that shows a way using the info button but this doesn't seem to work...
Hi, I have a problem with my Type 1 to Type 2 cable. Last year it stopped working and I traced it to the integrated micro switch which I replaced and all has been fine since until this week when yet again it stopped working. So I've checked it over with my multi meter but can't find anything...
Mitsubishi said they were unaware of this problem and suggested I take it in to have the sensors checked out. Went in yesterday and they have performed a software update for the pre heat and also adjusted the sensor sensitivity so will see how it goes. The outside temp has dropped this morning...
I was advised that Teamviewer would work mobile to mobile, however after contacting Teamviewer for confirmation they basically said thanks for the suggestion and we may look at this for future development, so it appears I'm back to square one on this. I see there is an app that works via text...
Yes, you're probably right but seems a bit pointless having a system meant for cold weather for it to set alarm off when being used. I've email mitsubishi so I'll see what they come back with
Well mine has starting do this now. Last week did it once and then twice this week with this morning being the last time. I'm using demist also so is it a case of only using the heat setting rather than demist or has anyone found another way to stop this as I'm sure the neighbours are soon going...