Recent content by Artorius

Mitsubishi Outlander PHEV Forum

Help Support Mitsubishi Outlander PHEV Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. A

    Twin Motor Lock question?

    Planning on going off the beaten path to do some charity work and chances are I won't find a charging point anywhere nearby. Just wanted to check if anyone knows if the Twin Motor lock will work even if the battery is zero. Since I believe it's an electric control system.. kinda concerned about...
  2. A

    How many miles (or km) have you managed on one tank?

    On two long distance out of town trips with no ability recharge she averaged about 15km/l..
  3. A

    Disconnect battery to install accessories?

    Apparently with genuine accessories, you don't need to do anything.. follow the steps and voilà.. its done.. no mess and no fuse.. interior illumination and scuff kit on in just over an hour by the installers..
  4. A

    Disconnect battery to install accessories?

    About to get down to work in a bit to install the interior illumination and the illuminated scuffs and realised that I don't know how or if the battery should be disconnected? Anyone done this before? I am assuming it's the 12V battery if at all, but concerned about any software issues that...
  5. A

    New Member from Sri Lanka

    It's less mud here and mainly fforest trails while elephant watching.. let me know how the tires stack up as well as the ground clearance.. that is actually my biggest concern.. :/
  6. A

    New Member from Sri Lanka

    Hahaha.. yup.. but I do some light off roading.. so will need to look at some good ATs after the factory Toyos wear away.. long time more..
  7. A

    New Member from Sri Lanka

    Hi to everyone.. I am a convert from a 07 Rav4.. had the PHEV for about a month now and done a couple of thousand kms in her.. really strange to own a vehicle that does better mileage in town running than long distance.. since I got her I've gone ahead and done a full 3M tint and just today put...
Back
Top