Recent content by MiG25

Hi Andy, Yes you are right ! I installed recently Quicklynks Bluetooth Battery Monitor ,but i was focusing on night , and totally not notice these 2:00PM :) https://www.youtube.com/watch?v=9LJDymGhJe0 Yesterday there where no drive at all ,car plugged to charger , and at 0:05 charger turn on...

Ok ,that is what i was not aware... Dead 12v couses not possibility to start charge traction battery. But somwhere i red , that (at least cars with wifi) start charging 12v battery in night ( like 1:00am) ,maybe this is also good hint to charge traction battery , if car is going to be not...

Bigger problem is the place of terminals , HJ-S46B24R has minus and plus in oposide place cmpared to HJ-S46B24L(S)

Battery 12V is quite small ,but well treated since it is always charging when: - Traction battery is charged - remote run heat or cool - Ready mode ,so during drive So if you charge traction battery every day , it is not possible to have 12v battery discharged ... So when after 3months car...

Did you saw this topic : https://www.myoutlanderphev.com/forum/viewtopic.php?t=2914&start=160 I'm using solution , with gave @amiralnar there.

But in manual transmission 1st gear is almost eveywhere up.... Sure there is a similarity to automatic , but fo sure it is also not logical. Swapping wires on plug with goes to stick should not be a problem , but it will ot change the situation on dashboard.

My wife have the same problem :) And have to admit ,that more intuitial would be swapped positions.

I'm also turning on standard charger everyday on 0:15 and have no problem with 12V battery. Difference is , that i'm not duing it by internal car timer , but by external Sonoff switch.

Ad.2. It is not a problem. Heater turned on remotely works . Ad.3 Ok , got it. Still sometimes get a lot of errors on start sometimes... I have to observe when this is happening .(My wife rapported two times this problem, she tuned off car ,got out ,locked , unlocked and start again , and it...

On this blue wire power also apear , when you start heat from Remote Ctrl App , so no need relays , everything is working without. Problem is only at beginning , but that is becouse ACC ECU is reset becouse of unplugged plugs for it. It needs some time ,or turn off/ on combinations to work (...

Yes with INT connected works much better , no issues at all during tests :) Please correct scheme , that would save some hours to other :)

I exchanged Arduino Nano with ATMega168 to new Nano with ATMega328P , but nothing changed, after a while some random errors and/or AC shutdown for some second. In program i found digitalRead from pin 2 and 3 ,but acc to scheme there is nothing connected to it. So either these pins should be...

I already munted it , but had some issues from booth sides , on AC side there where random on/off ,and at the same time fan stoping for a while , and from vehicle i got random errors on dashboard (like DPF , steering wheel , low engine oil , also some radio mutning). Today i exchanged arduino to...

Yellow Triiangle apear , when ther was same message showed firstly. I have it i.e. when i but a charger cable to plug , and then i pres onl the release button. On disply it shows something like "Charging stopped" and message disapears after while , but trianle stays.

Thank you ! Pars ordered , arduino had and it is already programmed :) Some questions: - Where exacly this C-205 plug is connected ? Is it enough to remove pannel with Aircon /radio ? - Is in this plug also +12V source sutable to power step/down converter for arduino ? ( would be ok , when...