Recent content by Pomst

Mitch, how do you know so much about MMC operations and functions of this vehicle? Secondly, my car has lost 8km range over the past 3 weeks. Which is absurd and unreasonable to be honest. Its down to 40km range when fully charged from the slow Euro-plug charger, Chademo got me 33km last time I...

Rest could be needed for cell balance since the discharge current is probably very low. Do you mean that all of those values are editable via MUT? Or, are all of them reset during Lindqvist? I highly doubt its the latter.

Is anyone able to answer what exact values exist when reading out the data via MUT cable? If we were able to see what value are changing during the Lindqvist and start fiddling around with them to see exactly what value gives this desired result then we will be able to get simple CANbus commands...

So apparently you know that they are running an isolated DC/DC converter. How did you get this knowledge?

That's a lot of assumptions. Good luck with your wood tractor.

I am going to try the method tonight, but a variant of it. I will try to short out the capacitors with a resistor between the Negative and Position terminal of the battery connectors after the 12V battery is detached. In theory, if there are no diods, this should drain the potential capacitors...

Yes, I know. But its clearly not working well and can be improved. https://youtu.be/7FAZwGEkg18?t=285 https://youtu.be/KnUxphPSjdI?t=432 https://youtu.be/B1ZHR02oxJ4?t=76 I tested this my self and the car stalls as soon as a wheel is in the air.

Yes, you are correct. The wiki was the best effort in a 10 second search for "any other battery". For the amount of time it took me it was "a very good proof". That doesn't mean its the best proof and I was not claiming it was the best either. I did, however, provide other documentation as...

That wasn't the question. The question was: Which was provided.

Well, my plan was to integrate with comma.ai to get the car to some state of self-driving. But without any method for the car to steer that would be a lot of work in hardware dev, which im not fond of doing right now. I'm not saying its bad, im saying that its bad for my project. I can be done...

Either you didn't read what I wrote or you don't understand how it works. The controllers do limit but not to 200w as they are slow and inaccurate. This in turn allows for a high in-rush current pushing far more power to the motor then legally allowed. Please get out the calculation for...

Yeah, this says it all: That sucks. Ill move on to the next task on my list then. Making the 4x4 Lock an actual functioning lock.

You will find it harder then a Google search or a forum whine to get specifications for cells older then 2007. What I found is what is available from 5 minutes of searching to prov a point about cycles on batteries and my calculation on how long these cells Should last. If its not acceptable to...

Does anyone have a 3D Scan of the PHEV? I am making some fender flares and would need the actual form of the fenders to make a perfect fit. There are a couple of models out there but they cost more then I would prefer to pay for this minor project...

That's an astute observation. This is my entire point. Cutting the BMU out of the loop would not reset any kind of capacity loss what so ever if it was the Actual cells that were degraded. Cutting the BMU out might actually allow for any bug (or feature or planned obsolescence) in the firmware...