Triple Procedure & Setup (Costs around 80USD)

[EarlVadim]

Hi.
For this operation (and for diagnostics) there is one more tool - MUT-config
But it only works on Windows x32.
It cost ~10usd..

[Stefunk]

The instructions in the 1 thread was how to install mut and drivers. But can somone explain procedure itself? Which function have to be selected, does the battery needs to be discharged, etc.

[Camsheim]

Did it yesterday with a low battery.

Bought the car last week end 30km info , after the 600km trip back 1st Charge 25km

Simple reset 50km

Reset via MUT 64km

DBCAM 75km full charge.

2 times this week we did almost 60km without the engine running.

Thanks for the info.

For the procedure, just check the menu (1st is Special Function Reset , the second is battery something , and the dbcam is under Battery Capacity auto Mesurement)

[delnaval]

Hi all, I am new in the forum, my name is Alfred from Madrid, Spain.
I bought my car last year and it has lost a lot of battery capacity since then. Currently I have 69.5% SOH.
I would like to try the triple procedure, but would like to know which tools and software I need to buy.
Please, can anyone help me?

[delnaval]

Did somebody run the "J2534 Pass-Thru" driver in combination with a mini VCI cable and the MUT III Software successfully on Windows 10 (32-bit or 64-bit) or is an old Windows 7 (32-bit) system required?

Both of 32 and 64 and XP, 7, 8, 10 are supported.

Hi Nikolai,
I have already a cable j2534, would like to get your driver. Can you send me the instructions?. I have a laptop with Windows 10 64bit installed, is not a problem?. Which version of MUT III do I need, do you have a link to download it?.
Thanks