EarlVadim
Posts: 3
Joined: Sun Jun 21, 2020 11:45 pm

Re: Triple Procedure & Setup (Costs around 80USD)

Sun Jun 21, 2020 11:53 pm

Hi.
For this operation (and for diagnostics) there is one more tool - MUT-config
But it only works on Windows x32.
It cost ~10usd..

Stefunk
Posts: 2
Joined: Mon Jun 29, 2020 7:55 am

Re: Triple Procedure & Setup (Costs around 80USD)

Mon Aug 24, 2020 12:57 am

The instructions in the 1 thread was how to install mut and drivers. But can somone explain procedure itself? Which function have to be selected, does the battery needs to be discharged, etc.

Camsheim
Posts: 1
Joined: Mon Oct 05, 2020 1:56 am

Re: Triple Procedure & Setup (Costs around 80USD)

Sun Oct 11, 2020 8:21 am

Did it yesterday with a low battery.

Bought the car last week end 30km info , after the 600km trip back 1st Charge 25km

Simple reset 50km

Reset via MUT 64km

DBCAM 75km full charge.

2 times this week we did almost 60km without the engine running.

Thanks for the info.

For the procedure, just check the menu (1st is Special Function Reset , the second is battery something , and the dbcam is under Battery Capacity auto Mesurement)

delnaval
Posts: 2
Joined: Sat Nov 21, 2020 11:18 am

Re: Triple Procedure & Setup (Costs around 80USD)

Sat Nov 21, 2020 11:33 am

Hi all, I am new in the forum, my name is Alfred from Madrid, Spain.
I bought my car last year and it has lost a lot of battery capacity since then. Currently I have 69.5% SOH.
I would like to try the triple procedure, but would like to know which tools and software I need to buy.
Please, can anyone help me?

delnaval
Posts: 2
Joined: Sat Nov 21, 2020 11:18 am

Re: Triple Procedure & Setup (Costs around 80USD)

Sat Nov 21, 2020 12:41 pm

kolyandex wrote:
Wed Oct 02, 2019 8:48 pm
sportster wrote:Did somebody run the "J2534 Pass-Thru" driver in combination with a mini VCI cable and the MUT III Software successfully on Windows 10 (32-bit or 64-bit) or is an old Windows 7 (32-bit) system required?
Both of 32 and 64 and XP, 7, 8, 10 are supported.
Hi Nikolai,
I have already a cable j2534, would like to get your driver. Can you send me the instructions?. I have a laptop with Windows 10 64bit installed, is not a problem?. Which version of MUT III do I need, do you have a link to download it?.
Thanks

Return to “Technical Discussions”